Phonosophie high-end Ethernet Cable

Phonosophie High-End Ethernet Cable

This network cable uses high-quality materials selected for sound quality to ensure that this CAT7 cable has maximum freedom from interference. A measurably large interference signature emanates from connections that transport a high-frequency signal. The intensity of these unwanted RF pulses has a direct, negative influence on the interpretation of the musical performance. Simply described: The lower the noise emission, the better the sound.

This effect is achieved by a consistent design of the cable: The four pairs of cables twisted together are each provided with their own shield to prevent intermodulation. In addition, a further shield surrounds the entire cable structure. The strands end in deliberately lightweight and therefore low-ground RJ45 connectors. The plug itself is made of a resonance-damping, non-hard material and thus counteracts vibrations in the socket. In addition, the locking lever is protected by a small plastic tongue so that it does not break off.

The fabric jacket gives the cable a high-quality appearance, above all the fabric very effectively prevents vibrations. Like all cables, a network cable must neither vibrate itself nor be subjected to unnecessarily strong vibrations. Every cable goes through an extensive test course after production. To do this, it is connected to a test device and the data transport checked for errors. This enables us to ensure that each Ethernet cable can meet all specified parameters.

Specifications:

• 10 Gigabit Ethernet cable (F/FTP Foiled/Foiled Twisted-Pair) with an operating frequency of up to 500 MHz and a transmission rate of up to 622 Mbit/s
• Fabric coat black with red thread
• Wire gauge: 32 AWG
• Conductor material: tinned, oxygen-free copper
• Insulation resistance: 10 MOhm Min
• Conductivity resistance: 30HM Max
• Available lengths: 1,0m; 1,8m; 3,0m; 5,0m und 10,0m